ST1100Y
Site Supporter
You might loosen the flange again and redo it once the rear wheel is installed for proper alignment...
Last edited:
AZ 2005 build - Are you ready for another one?
- Thread starter SupraSabre
- Start date
OP
OP
OP
OP
Well, not really progress, but yesterday I realized that when I put the swingarm back on, I had the rubber dust cover on the swingarm, instead of the back of the engine, like you are supposed to! 
When I pushed the swingarm forward the rubber dust cover got caught in the u-joint! And there was no way to pull it out of the shaft area. So, I had to pull the swingarm back off, and reset the dust cover to the back of the engine and pushed the swingarm back in place and bolted it back up.
Well, at least now, I'm proficient at removing and re-installing the swingarm!
And I'm done for the week.
When I pushed the swingarm forward the rubber dust cover got caught in the u-joint! And there was no way to pull it out of the shaft area. So, I had to pull the swingarm back off, and reset the dust cover to the back of the engine and pushed the swingarm back in place and bolted it back up.Well, at least now, I'm proficient at removing and re-installing the swingarm!
And I'm done for the week.